Echoflex Installation Guide
Access Interface
2. Hook the top of the wall plate to the tabs located on the Interface
electronics assembly. To ensure the wall plate is hooked properly on
the top hook, wiggle it slightly side to side.
3. Swing the bottom of the wall plate down until the magnets engage.
4. If the wall plate does not fully attach automatically, wiggle the
bottom of the plate until all of the magnets are seated properly to the
Interface and the plate is secure.
Note:
If you are installing a multi-gang wall plate and the
stations are misaligned in the mounting box, the wall play will not
attach properly. Loosen the screws that secure the station to the
back box, adjust each station to improve the alignment, secure the
screws, and then repeat the installation of the wall plate.
Restore Factory Defaults
The Reset button on the back of the ElahoAccess Interface lets you
restore the Interface to its default factory settings.
Reset
Button
1. Access the back of the Interface.
2. Press and hold the Reset button for 10 seconds. The blue Power LED
light blinks once when the reset is complete.
Access Interface
Page 6 of 8
Echoflex
