background image

Echoflex Installation Guide

Access Interface

Note:

This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. Any modifications or
changes to this product not expressly approved by Electronic
Theatre Controls, Inc. could void the user’s authority to operate
the product. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be
required to correct the interference at their own expense.

This device contains a wireless module with the following identification
numbers:

FCC ID: T9JRN4020

ISED Compliance

This device contains a license-exempt transmitter/receiver that complies
with Innovation, Science, and Economic Development Canada’s license-
exempt RSSs. Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that

may cause undesired operation of the device.

Contains IC ID: 6514A-RN4020

CAN ICES-003 (A)

Conformité ISDE

Cet appareil contient un émetteur/récepteur conforme aux CNR
d'Innovation, Sciences et Développement économique Canada (ISDE)
applicables aux appareils radio exempt de licence. Son fonctionnement
est soumis aux deux conditions suivantes:

1. L'appareil ne doit pas produire d'interférences.
2. L'utilisateur de l'appareil doit accepter toute interférence, même si

l'interférence est susceptible d'en compromettre le fonctionnement.

Contient ID IC: 6514A-RN4020

CAN NMB-003 (A)

Access Interface

Page 8 of 8

Echoflex

Summary of Contents for ElahoAccess









Reviews: