Echoflex Installation Guide
Multi-Scene Station
Multi-Scene Station
Page 3 of 4
Echoflex
Battery Power
A CR2032 is supplied with the station. The battery may be factory installed
or packed separately according to shipping regulations. Insert the battery if
required or remove the protective plastic tab before installing the station.
During normal operation, if the green LED blinks once, the battery is strong
and a message was sent. If the red LED blinks once, the battery is weak but
the message was sent. If critically low, the red LED blinks three times and
cannot transmit. If the red LED blinks once every minute the battery must be
replaced. To replace the battery:
1:
Remove the faceplate, and then unscrew the station from its
mounting location, and slide off the battery cover.
2:
Insert a flatblade screwdriver under the battery clip and gently pry it
free.
3:
Press the On button for 10 seconds to discharge any stored energy.
4:
Insert the new battery into the clip with the positive side (+) up and
press down. If successful, an LED chase sequence will run three times.
Tests and Settings
The
[Test]
button provides access to a menu of tests and settings.
Operational and navigational feedback is provided via the color LEDs. The
menu times out after two minutes. To access the menu:
1:
Remove the faceplate to access the
[Test]
button.
2:
Press and hold the
[Test]
button until all the LEDs blink.
3:
Tap the
[Test]
button to cycle through the menu (see table below).
4:
Press and hold for five seconds to select based on the LED blink.
Disregard any other LEDs that blink; they are for factory use only.
Reboot
The LEDs will run a chase sequence three times to confirm successful reboot.
Tests and Settings Menu
Single red blink
Reboot
Single amber blink
Range Confirmation