2
Product Overview
The wireless switches communicate with controllers to activate the controllers
internal relay. In most applications, the controller’s relay is connected to a
lighting load or circuit and the wireless switch functions as a basic light switch.
The switches requires no wiring connections and use no batteries. The kinetic
energy of a finger press with the ON or OFF side of the switch generates enough
energy to transmit the switch event.
Some models have 4 buttons or dual paddles, these operate identically to the
single paddle switches. With dual switch models, each switch is separate from
the other and can be assigned to the same controller or a different controller.
Mounting the Switch
Careful consideration should be made for locating the controllers and switches
based on the construction materials in the space and possibility of tenant’s
furniture disrupting the transmissions. The switch should be installed in the
space where the controller device is controlling the light fixtures or circuits
however the signal will travel through material barriers, refer to the range
planning section for more information.
All switch models can be mounted on any surface;
wall, desk, cubicle wall,
etc. with double sided tape (supplied with ETRS models only) or Velcro™ (not
supplied). The
ON
side of the switch should be mounted on the top; The
“I”
indicates
ON
(on the front of the Wave and the back of the Decora switches).
The
“O”
indicates
OFF
. The Resonate Handheld switches have a depression on
the
ON
side of the paddle.
Decorator style switches
have four (4) mounting holes in the rear mounting
plate to attach the switch to a wall surface with screws and wall anchors (not
supplied). Install a decorator style faceplate (Leviton 80401 or equivalent-not
supplied) over the switch. Test operation of the switch. The paddle should return
to a neutral position after release. An audible click is expected.
The Wave switches
come supplied with double sided tape, you can also remove
the front cover of the switch and use the screw guides on the back plate of the
switch to mount with screws and wall anchors (not supplied)
Hand Held switches
have round removable covers on the back (twist off, using
small holes for leverage). There are keyholes behind the covers. Use with pre-
installed screws (not supplied) - measure 6 cm center to center when placing
screws.
The Key Card switch
is activated with an 85.60 x 53.98 mm (3.37 x 2.125”) card
as specified by ISO/IEC7810 - ID-1 (thickness of 0.76 mm (0.03”).
For wall mounting, the keycard switch faceplate must be removed before
mounting with screws. For proper operation, the provided rear mounting plate
must be used when mounting.
1. Remove the faceplate screws and faceplate assembly (includes front cover
and insert with key depression tag).
2. There are four (4) mounting holes in the rear mounting plate to attach the
switch to a wall surface with screws and wall anchors (not supplied).
