Echoflex Installation Guide
Wireless Switches
Wave Switch (ETRS)
The ETRS model includes clear, double-sided tape to mount the mobile
switch to glass when it is not in use. The switch also can be surface-
mounted securely to a wall.
1. Pull to remove the front cover and access the two mounting hole
targets on the back plate.
2. Mount the back plate to a wall with screws and wall anchors (not
provided) and replace the front cover.
Handheld Switch (ETRH)
Twist-off
covers
The ETRH model is designed to be portable,
but it also can be surface-mounted to a wall
using the two keyholes on the back.
1. Remove the covers to expose the
mounting keyholes. Use the two holes
for leverage to turn 90 degrees.
2. Install screws and wall anchors (not
provided) aligned to 6 cm (2.4 in) on
center to hang the switch.
Keycard Switch (PTM265KCA)
The PTM265KCA model has a removable
faceplate and rear plate for surface-
mounting to a wall. The switch is activated
by a 85.60x53.98 mm (3.37x2.125 in) card that is 0.76 mm (0.03 in)
thick, as specified by ISO/IEC7810 ID-1.
1. Remove the faceplate screws and assembly that includes the front
cover and keycard slot.
2. Use the four mounting holes in the rear mounting plate to attach the
switch to a wall surface with screws and wall anchors (not provided).
Note:
The keycard switch can be mounted to an electrical wall box
using a barrier partition accessory, which is sold separately.
3. Reattach the faceplate assembly. Do not over-tighten the screws.
4. Test the card action. An audible click confirms the switch activation
with each insert and removal.
Wireless Switches
Page 3 of 8
Echoflex
