19
Wireless TimeClock Configuration Guide
Manage Controllers
Echoflex devices that are part of an installed solution may be configured
during the Echoflex pre-commissioning process or at any time using Garibaldi
Pro commissioning software. A number of the parameters can be configured
from the devices themselves (see relevant documentation for details). The
WTC also provides a means of linking controllers. See
planning information.
Link or UnLink
The WTC sends a Teach message to Link or
Unlink to a controller. The target controller
must be installed, powered, and within range
of the WTC. See
for how to identify a controller.
1. Press the [Learn] button on the controller
to activate Link Mode.
2. Select
Link or Unlink
from the Manage Linked Devices menu, and press
[Enter]. Repeating the linking process can be used to Unlink the
controller.
3. Press [Enter] again to send a Teach message. A confirmation message
displays that the controller’s radio ID has been Linked or Unlinked.
Linked Controllers
The WTC supports up to 20 linked controllers.
A unique radio ID identifies each controller
and each channel for multi-channel
controllers.
1. Select
Linked Controllers
from the
Manage Linked Devices menu, and press
[Enter].
2. Press [Up] or [Down] to scroll the list of radio IDs, and press [Enter] to
select a controller to configure.
Configure Controller
The Config Controller menu provides communication tools to confirm
communication with controllers.
Link or Unlink
Press Enter to send
a Teach message.
ID 058CF385 linked.
Linked Controllers
058CF385
0595648D
0477230D
Config Controller
Blink Controller
Test Connection