16
Go in to the “
Motorized dish setting
” menu with the key to “
E
rase Position Data
” and press the
OK
key. Then go to “
Erase
All Satellite Data
” press the
red
key twice. Press
the
MENU
k
ey, go to Installation, Motorized Dish Setting, Antenna Installat
ion, press the
OK
key and proceed from start.
If you are not satisfied with the Limit parameters e.g. since the
mechanical limits might not be set properly, you can erase the
position data and start again after adjusting the mechanical
limits at the dish.
Motorized Dish Setting
Erase Position Data
Select in the Erase Position Data Menu “
Set Present Sat as f
ixed
”, using the , keys.
If signals from this satellite are received with a fixed dish, th
e movable dish will not move to this satellite.
Erase Position Data
Erase All Satellite Data
Set present SAT as fixed
1
2
Delete Cancel
i
Exit
Motorized Dish Setting
Erase Position Data
Antenna Installation
2
1
Exit
i
Motorized Dish Setting
Erase Position Data
Antenna Installation
1
2
Exit
i
The
EchoStar AD-3000IP VIACCESS
now has
programmed the position of all selected satellites.
The next step is to store all channels on these
satellites. To do this press the
MENU
key, select
the Installation option followed by the Program
Satellites option. Use the key to select the next
satellite and press the
OK
key. The dish will
move to the selected satellite.
Select Start Search to store all channels.
Repeat this procedure for all satellites.
Program Satellites
LNB Type Type 1
TP/Pol/SR(Digital) 11662/V/27500
Skew Not set
Position E 1070 W
Re-align Dish +00
Search Type Auto Search
Start Search (Press OK)
Satellite 013.0
?
E
1
2
4
3
5
6
7
8
×
HOTBIRD
Ø
[E 1070 W]
EL
WL
Signal Level 10%
Signal Quality 5%
Program Satellites
