Page 57
Using the Remote Controls
3. If you see the
System Info
screen, press the
SELECT
button to close the
screen. You have recovered your satellite video.
4. If you do not see the
System Info
screen, repeat steps 2 and 3 until you
have recovered your satellite video.
Note
: Press any remote control button other than the
RECOVER
button to
end this procedure.
Note
: If the
RECOVER
button is not programmed to a specific channel,
the
RECOVER
button will first try to tune your TV to channel 3, then
channel 4, and then other video inputs with each press of the
RECOVER
button. You may need to press the
RECOVER
button up to 30 times to
recover your satellite TV video. If the
RECOVER
button is programmed to
a specific channel (see page 25), the
RECOVER
button will tune the TV to
the specific channel (for example, channel 60).
DVR Buttons
Use these buttons to record or play back a DVR program. See
Using the DVR
Features
on page 85 for details.
PIP Button
Press the
PIP
button to open the
PIP
window. To make the
PIP
window larger,
press this button again. Press the button a third time to close the
PIP
window.
This button is active only in
Single Mode
.
Swap Button
Press the
SWAP
button to swap the video in the main display with the video in
the
PIP
window. This button is active only in
Single Mode
.
Position Button
Press the
POSITION
button to move the
PIP
window to different positions on
the TV screen. Each press of this button move the
PIP
window. This button is
active only in
Single Mode
.
