www.echostar-int.com
Page 2 - 15
©
20
04
Ech
o
S
tar
In
te
rn
ati
o
nal
C
o
rp
or
at
io
n
Al
l ri
g
h
ts
r
e
s
e
rv
e
d
14.
M
ENU
STRUCTURE
M
AIN
MENU
NOTE
Some menus have a signal indicator which you can use to find the best signal for the selected satellite. The top banner shows the Signal quality
and the bottom banner shows the Signal strength
1. Search channels
Program SAT
SAT
To define the satellite you want to search channels on. For motorized systems, allow the dish
some time to move to the selected SAT until the signal indicator shows a reading.
Red: Direct access to the search mode menu.
Tuner
(T1-T2 only)
To define the tuner for the selected SAT.
TP
Shows a transponder, from the internal database, of the defined SAT. If the signal indicator
shows low levels, select another TP that gives a better signal.
Red: Direct access to the search mode menu
Blue: Direct access to the Add/Edit data menu; to add/edit a SAT or TP that is not listed
(for detailed information refer to the explanation of the Add/Edit data menu.
LNB Power
To switch the LNB power to On (for dishes) or Off (for distribution networks).
Red: Direct access to the search mode menu.
LNB
To define the LNB that you use in your system.
Red: Direct access to the search mode menu
Blue: Direct access to the Edit LNB menu; to add a LNB that is not pre-programmed.
Edit LNB
LO low
To select the Low Band Local oscillator Frequency.
LO high
To select the High Band Local oscillator Frequency.
22kHz
To switch the 0/22kHz control signal to On for port 1 or Off for port 2.
(only selectable when you select a LNB that is not a Universal LNB).
Red: Direct access to the search mode menu.
0/12V switch
To select the port for the selected satellite, 0V for port 1 or 12V for port 2.
Red: Direct access to the search mode menu.
DiSEqC switch
(Fixed only)
To select the DiSEqC switch that you use in your installation. Select DiSEqC 1.0 for committed
switches and DiSEqC 1.1 for uncommitted switches.
Red: Direct access to the search mode menu.
