www.echostar-int.com
Page 3 - 3
©
20
04
Ech
o
S
tar
In
te
rn
ati
o
nal
C
o
rp
or
at
io
n
Al
l ri
g
h
ts
r
e
s
e
rv
e
d
3. The TV shows a
No Signal
message.
■
Bad reception of the
signal.
■
Make sure the
channel selected
transmits.
■
Make sure the
correct dish or LNB is
selected.
■
Make sure the dish
and LNB are clean
and correctly
adjusted.
4. The TV shows a
“Scrambled signal”
message.
■
Smartcard problems
■
Read the solutions in
to solve smartcard
related problem.
5. There is no Dolby
Digital (AC-3)
sound to my other
equipment.
■
The equipment is
connected to the
receiver with a RCA
or SCART cable only.
■
Connect the
S/PDIF connector of
the receiver to the
Dolby Digital input of
the Dolby Digital
amplifier.
■
The Dolby Digital
option is not set to
On.
■
Press the MENU key.
■
Select main menu 3.
■
Select User profile.
■
Set the Dolby Digital
option to On.
6. There is no audio
while I watch a
Dolby Digital
program.
■
The Dolby Digital
amplifier is set to Off.
■
Set the Dolby Digital
amplifier to On.
■
The receiver is not
connected to a Dolby
Digital amplifier.
■
Press the MENU key.
■
Select main menu 3.
■
Select User profile.
■
Set the Dolby Digital
option to Off.
Problem
Possible cause
What to do?
7.
I
NSTALLATION
RELATED
Problem
Possible cause
What to do?
1. During (initial) setup
of the receiver, no
channels are found.
■
You did not select the
correct LNB(F).
Universal LNB
05150 - C-band
09750 - FSS
10000 - FSS
10050 -
10060 - DBS
10750 - DBS
11200 - AUSAT
11475 - Telecom
■
On the receiver, in
the Program SAT
menu select the
correct LNB(F).
■
Press the Blue key to
edit the LNB.
■
When installed, you
have selected the
incorrect switch type
or port.
■
On the receiver, in
the installation setup
menu make the
correct selections.
■
You have selected
the incorrect satellite
to search channels
on.
■
On the receiver, in
the installation setup
menu select the
correct satellite.
■
You have selected
the incorrect search
method.
■
At an initial setup,
always choose the
option All.
2. My television does
not receive any
signal from the
receiver (UHF only)
■
You did not select the
correct Audio/Video
channel on your TV.
■
Refer to the user
guide of the TV for
instructions.
■
On the receiver, In
the TV system menu
select the correct
UHF channel and
PAL setting.
■
Use another method
to connect the
receiver.
