Page 1 - 6
EchoStar International Corporation
© 2
0
04
Ech
o
S
ta
r I
n
te
rn
at
io
na
l
Co
rpor
a
tio
n
A
ll ri
gh
ts
re
serve
d
D
I
SE
Q
C 1.2 - L
OOP
-
THROUGH
9. In the System setup menu, select:
System: DiSEqC1.2;
Tuner: Loop-through.
10. Select Move: press the
key to move the
dish to the West limit.
11. Select Set limits: press the
key, select
West limit and press the OK key.
12. Select Move and press the
key to move
the dish to the East limit.
13. Select Set limits: press the
key, select
East limit and press the OK key.
14. Select Set limits: On.
15. Press the Red key to advance.
16. In the Program SAT menu, select your
satellite and make sure, the signal indicator
shows a reading.
17. Select the System option and press the blue
key to advance.
18. Select Move continuous and move the dish
to find the satellite.
19. Select Fine tune and move the dish to find
the best signal.
20. Press the Red key to advance.
21. In the Search mode menu, select: All.
22. Press the Red key to advance.
23. Wait for the Search channels to complete.
24. Select the next satellite.
25. Repeat steps 16. - 23. for each satellite.
CAUTION
On the motorized dish, set the physical limit
switches first. Failing to do so might cause
damage to your dish or other properties.
D
I
SE
Q
C 1.2
Select System: DiSEqC, Tuner; Loop-through.
Select your satellite.
Move the dish to find the best signal.
D
I
SE
Q
C 1.2
Select Search mode: All, press the Red key.
Wait for the search channels to complete.
Press the OK key to confirm.
