|
26
MN300820 Rev B4
Configuration Using Display
Step
Four
EchoTouch
®
can be configured before installation. The transmitter features non-volatile memory, so any
setting configured before installation will not be lost when the switch is powered down. To configure, follow the
steps below: (Pages 27 to 31)
1. Measure the Tank
a. Begin by measuring the key tank and fitting dimensions.
b. Correct tank dimensions will result in accurate sensor measurement.
2. Set the Units of Measurement (
UNITS
)
a. Units can be configured in basic engineering units of length including Feet, Inches, Centimeters
or Meters.
3. Set the Sensor Height (
HEIGHT
)
a. This is the empty setting (4mA) for the tank.
4. Set the Fill-Height (
FILL-H
)
a. This is the full setting (20mA) for the tank.
5. Set the Fail-Safety (
SAFE
)
a. This is the maximum measurement range for the sensor. The sensor will ignore all echo returns
beyond this setting.
NOTE:
When configuring EchoTouch
®
, choose either the WebCal
®
or Push Button method. Either method will
accomplish the goal of sensor configuration. Changes to the configuration can be made using the alternative method.
When beginning with one method, it is recommended to complete the configuration before using the other method to
make any adjustments.
NOTE:
Display configuration is only available with the US06 & US12 series.
EchoTouch
®
peut être configuré avant l'installation. L'émetteur dispose d'une mémoire non volatile, de sorte
que tout réglage configuré avant l'installation ne sera pas perdu lorsque le commutateur est mis hors tension.
Pour configurer, procédez comme suit: (Pages 32 à 36)
1. Mesurer le réservoir
a. Commencez par mesurer le réservoir de clés et les dimensions de montage.
b. Les dimensions correctes du réservoir entraîneront une mesure précise du capteur.
2. Définissez les unités de mesure (UNITS)
a. Les unités peuvent être configurées dans des unités d'ingénierie de base comprenant des
pieds, des pouces, des centimètres ou des compteurs.
3. Réglez la hauteur du capteur (HAUTEUR)
a. C'est le réglage vide (4mA) pour le réservoir.
4. Définissez la hauteur de remplissage (FILL-H)
a. C'est le réglage complet (20mA) pour le réservoir.
5. Configurez la sécurité d'échec (SAFE)
a. C'est la plage de mesure maximale pour le capteur. Le capteur ignore tous les retours d'écho
au-delà de ce paramètre.
REMARQUE:
lors de la configuration d'EchoTouch®, choisissez la méthode WebCal® ou Push Button. L'une ou
l'autre méthode atteindra l'objectif de la configuration du capteur. Les modifications apportées à la configuration
peuvent être effectuées en utilisant la méthode alternative. En commençant par une méthode, il est recommandé de
compléter la configuration avant d'utiliser l'autre méthode pour procéder à des ajustements.
REMARQUE:
la configuration de l'affichage n'est disponible qu'avec les séries US06 & US12.