|
38
MN300820 Rev B4
Installation
Step Five
EchoTouch
®
doit toujours être monté perpendiculairement à la surface du liquide (utilisez le joint de fixation
Viton
®
fourni uniquement pour les versions filetées G). Assurez-vous que les fils de montage et d'émetteur ne
sont pas endommagés ou usés. Toujours serrer à la main l'émetteur dans le raccord. Effectuer un test
d'étanchéité installé dans des conditions de processus normales avant le démarrage du système.
GUIDE DE MONTAGE
1. Ne pas monter à angle
2. Le liquide ne devrait jamais entrer dans la bande
morte
3. Mur latéral:
a. Montez au moins 3 "de la paroi latérale
4. Ne pas monter où les obstacles s'immisceront sur la
largeur du faisceau du capteur.
a. monter au moins 3 "de la paroi latérale
5. Ne pas monter sous vide
6. Ne pas monter au centre d'un réservoir en forme de
dôme.
7. Dans le réservoir inférieur cône, positionnez le
capteur sur la partie la plus profonde du réservoir.
Installation dans les raccords existants:
si le raccord
existant est plus grand que les fils de l'EchoTouch®,
sélectionnez une douille réductrice telle que le LM52-2400
(filetage 3 "x 2") ou LM52-3400 (filetage 4 "filetage x 2")
LM52-2400
Ne pas installer à
un angle par
rapport au liquide.
Ne pas installer à
moins de 3 po de la
paroi latérale du
réservoir.
Ne pas installer
avec des objets
dans la poutre.
Ne pas installer
dans des
applications avec
vide.
Ne pas installer au
centre d'un
réservoir en forme
de dôme.