12
Use the strap to take the weight of the 2-in-1 Trimmer and Lopper, especially when the telescopic
poles are fully extended.
Using the strap to its potential will make trimming much easier, faster and less tiring.
Hedge Trimmer Assembly
2. The tube is hexagonal shaped and will only fit one way. Insert the telescopic pole (part No.20)
into the Hedge Trimmer head in direction A (see Figure 3 below),
until the locking holes click into
place. Make sure the slot 1 on the telescopic pole and two screwed holes (number 2 in Figure 3
below) are in line.
3. Insert the locking knob into the screwed holes (see Figure 4 below), then tighten the locking knob
by turning screw firmly. Make sure that connection is tight.
1. Loosen and remove the locking knob from the linking handle (see Figure 2 below):
Figure 3
A
Figure 2
Summary of Contents for EKETC01E
Page 10: ...10 V Part Identification 6 1 7 3 2 8 20 9 22 10 12 4 5 11 ...
Page 21: ...21 ...
