12
3.
If the amplifier is delivering a continuous or very low frequency signal that
could damage the loudspeakers.
WARNING: If these indicators are permanently lit, even if all signal
input and output cables have been disconnected from the amplifier,
this could be a malfunction symptom that should be analysed by the
official Ecler service centre.
Indicators “CLIP”
: They are lit when the amplified signal present at the amplifier
output is just below the clipping or saturation point. This system always provides
a true indication, regardless of variations in mains voltage. It is normal for the CLIP
indicators to light up briefly at high power levels at the rhythm of low frequencies,
as these are the frequencies with the highest energy input in the audible
spectrum. Care should be taken to ensure that these indicators are not
permanently lit during normal operation of the amplifier.
Indicators “SIGNAL”
: They warn of the presence of signal at the amplifier inputs.
These indicators illuminate when the signal present at the input exceeds a
threshold of -40 dB.
7.
CLEANING
The cover should not be cleaned with solvents or abrasive substances as there is a risk
of damage to the screen printing. To clean it, use a cloth dampened with water and a
neutral liquid detergent and then dry it with a clean cloth. Under no circumstances
should water be allowed to enter through any of the holes in the appliance.
Summary of Contents for eLPA2-350
Page 1: ...v 20190504 eLPA2 350 AMPLIFIERS Light Stereo Amplifier USER MANUAL ...
Page 10: ...10 ...
Page 13: ...13 8 FUNCTION DIAGRAM ...