16
7.7. Restore default settings and update firmware
If you would like to restore the CA120 to factory settings, follow this procedure:
1.
Unplug the equipment then press and hold the knob in.
2.
Plug back the unit without releasing the knob. The MUTE LED indicator will flash.
3.
Wait a few seconds and then switch the CA120 off again.
4.
The next time you turn it on, the factory settings will be in the memory.
Note:
for instructions on how to update the unit's firmware, see the product web page
, where you will find the update software utility and instructions on
how to proceed.
CLEANING
The CA120 must not be cleaned with solvents or abrasive substances which may
damage the prints. Clean using a cloth moistened in water and a neutral liquid detergent,
then dry with a clean cloth. Under no circumstances allow water to enter any of the
orifices in the equipment.
