7
5.
Fit the bracket in place, after threading the line and loudspeaker wire through the
square hole in the bracket. Secure the bracket to the wall:
6.
Connect the power supply cables, signal input and link between the two units to
the connectors on the rear part of the housing. Ensure correct polarity in the
Euroblock terminals.
7.
Place the acoustic box in its final position, sliding it vertically downwards so that
the rear side of the rail slots into the bracket rail.
8.
Secure the safety wire on the rear part of the acoustic box to ensure that it does
not accidentally fall and cause any material and/or personal damage.
9.
Orientate the box to achieve the required position on the vertical and horizontal
axes. Tighten up the Allen screws on the bracket to fasten this position on both
axes.
