8
7.
START UP
7.1. eMOTUS5P
To start up the system, turn on the MASTER (L) unit with the switch on the rear panel
and adjust the volume and equalizer to the required settings.
You may select the audio source (balanced or non-balanced input) by pressing the
rotating volume encoder.
7.2. eMOTUS5PB
To start up the system, turn on the MASTER (L) unit with the switch on the rear panel
and adjust the volume and equalizer to the required settings. Pressing the rotating
volume encoder, the unit will be muted.
You can select the audio source (balanced, non-balanced input or wireless connection)
by pressing the relevant button on the remote control: BAL, UNBAL or BT.
7.2.1. Wireless connection
Press the
BT
key to select the wireless connection mode. For pairing the BT, the
eMOTUS5PB is displayed on other devices as the eMOTUS5 (password:”0000”). Once
paired with the emitting device, the eMOTUS5PB will act as a receiver/reproducer of the
audio emitted by the former.
Note:
To safeguard the system from any possible power surges in the electrical supply,
there is a network fuse in the MASTER unit, located in a screw mount fuse holder in the
rear panel. In the event of this blowing, disconnect the device, remove it from the wall
bracket, unscrew the fuse holder, take out the fuse and replace it with another with
identical characteristics. If the new fuse blows straight away, consult our Technical
Department.
