10
Note:
in this mode, if (by mistake) the primary and secondary ports connect to
the same Ethernet network, Dante Controller will no longer have access to the
network configuration control and routing Dante™ of the MIMO4040DN ports.
This control is recovered when one of them is disconnected from the same
network as the other.
Nota:
Dante™ redundancy requires that the primary and secondary ports of all
Dante™ devices connect using the same network connection speed. For
example, if the primary port connects to a network with a 1 Gbps link, the
secondary
port
must
also
connect
at
1
Gbps.
Switched mode:
in this mode only a single network connection is actually
enabled (and therefore only one IP address exists), with the primary and
secondary ports behaving as ports of a network switch integrated within
MIMO4040DN, to which devices forming part of the system's Dante™ network,
or Ethernet switches forming part of that network's infrastructure, can be directly
connected.
Nota:
in this mode both ports
primary and secondary, should never be
connected simultaneously to network switches
, as this would create a loop that
would cause network conflicts and disruption of the digital audio Dante™ traffic.
