6
1
SW
1.2
IMPORTANT SAFETY INSTRUCTIONS
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this device near water.
6.
Clean only with dry cloth.
7.
Do not block any ventilation
openings. Install in accordance with
the manufacturer’s instructions.
8.
Do not install near any heat sources
such as radiators, heat registers,
stoves, or other device (including
amplifiers) that produce heat.
9.
Do not defeat the safety purpose of
the polarized or grounding type plug.
A polarized plug has two blades with
one wider than the other. A grounding
type plug has two blades and a third
grounding prong. The wide blade or
the third prong are provided for your
safety. If the provided plug does not
fit into your outlet, consult an
electrician for replacement of the
obsolete outlet.
10.
Protect the power cord from being
walked on or pinched particularly at
the plugs, convenience receptacles,
and at the point where they exit from
the device.
11.
Only use attachments/accessories
specified by the manufacturer.
12.
Unplug the device during lightening
sorts or when unused for long periods
of time.
13.
Refer all servicing to qualified
personnel. Servicing is required when
the device has been damaged in any
way, such as power supply cord or
plug is damaged, liquid has been
spilled or objects have fallen into the
device, the device has been exposed
to rain or moisture, does not operate
normally, or has been dropped.
14.
Disconnecting from mains: When
switching off the POWER switch, all
the functions and light indicators of
the unit will be stopped, but fully
disconnecting the device from mains
is done by unplugging the power
cable from the mains input socket. For
this reason, it always shall remain
easily accessible.
15.
Equipment is connected to a socket-
outlet with earthing connection by
means of a power cord.
16.
The marking information is located at
the bottom of the unit.
17.
The device shall not be exposed to
dripping or splashing and that no
objects filled with liquids, such as
vases, shall be placed on device.
1.3
CLEANING
Clean the unit with a soft, dry clean cloth or slightly wet with water and neutral
liquid soap only, then dry it with a clean cloth.
Be careful that
water never gets
into the unit through any hole. Never use alcohol, benzine, solvents or abrasive
substances to clean this unit.
NEEC AUDIO BARCELONA, S.L.
accepts no liability for any damage that may be caused
to people, animal, or objects due to failure to comply with the warnings above.
