18
SYSTEM TOPOLOGY AND CONFIGURATIONS
Note:
Connecting or disconnecting HDMI cables while VEO devices are switched on may
result in video signal dropouts while a stable connection is re-established.
8.1. Point-to-point connection
When the VEO-XTI2L and VEO-XRI2L are connected as a simple extension within a
point-to-point topology, no configuration is required. The devices have a default setting
of "Auto IP" (169.254.x.x), and each transmitter will send a unicast video stream to the
corresponding receiver when the same Group ID is selected. Point-to-point connection is
the default.
8.2. Point-to-multipoint connections and operations
When the VEO-XTI2L and VEO-XRI2L are connected as a distribution system within a
point-to-multipoint connection, both the transmitters and the receivers must be
configured as multicast
(refer to the ‘Which functions are available when operating the
devices via EclerNet Manager?’, ‘
Configuring the Casting Mode using the Control Centre
and ‘
’ chapters in this manual). Each receiver must be set to the same group
ID as the transmitter.
