29
It is also possible to add Net String buttons, in order to operate these devices using control
commands. This operation is described in the "
Ecler VEO-XTI2L and VEO-XRI2L TCP-IP
" document associated with this user guide.
CONFIGURATION USING VEO XTI2L - XRI2L CONTROL CENTRE
If any of the devices has firmware that is older than version 2.00r0, it will not be
compatible with EclerNet Manager. In this case, the only available way to manage the
equipment will be by means of the
VEO-XTI2L - XRI2L Control Centre
utility software for
PC. Once the software is installed, make sure that the PC and the VEO devices are within
the same network domain. To check the IP address o
f the devices, refer to the ‘
find out the IP address of devices
’ chapter.
10.1. How to find devices using Control Center
Run the software and the device scan page will appear. Click on the "Start Scan" button
to search for active devices on the network, and find out their IP address. By default, both
transmitters and receivers are set to "Unicast" and "Auto IP" mode.