52
If the "Never Timeout" parameter is selected as the time frame, then the last video frame
prior to the loss of video signal will be remain indefinitely, until another video stream is
detected or the transmitter is restarted.
11.4.2. Setting the scalar output mode for the transmitter
On the Transmitter Function page, you can select the maximum transmission speed for
the generated transmission.
It is possible to set the transmission speed at a value of 10 to 200 Mbps, with a "Best
effort" option that optimizes the transmission speed according to the video input.
11.4.3. USB over IP data extension
This section allows you to select the USB extension options.
•
Enable USB over IP:
Select to enable USB over IP extension mode
•
Operating mode:
o
Auto select mode
: will automatically select "active on link" or "active per
request", depending on the casting mode
o
Active on link
: USB transmission from transmitter to receiver. Suggested
for unicast scenarios
o
Active per request
: if several KVM endpoints are controlling one PC, for
example, the USB link will be activated on request. Suggested for multicast
scenarios
