USER MANUAL / MANUAL DE USUARIO
– MICROSTAR
Page
25
of
60
INMANUUML017 USER MANUALM. USO OM-100 V.2022.05 ENGESP US
Place the cover on the microscope.
Disconnect the AC interlock cable from the electrical network and tie it firmly to the
microscope’s column.
Loosen the wheels brakes.
Two people should move the microscope due to its weight.
Do not circulate over slanted surfaces with an angle larger than 10º, avoiding tipping over
the microscope.
By following these recommendations accidents during transportation and any further damage to
the microscope due to incorrect handling will be avoid.
7. MAINTENANCE
To maintain optimum operation of the Ecleris Microstar OM-100 Microscope, it is recommended
to perform a simple revision of the equipment once a year.
This procedure should include:
Lubrication.
Cleaning.
Revision of electrical connections.
Revision of lamps.
Spare parts: to avoid loss of time, and an inoperative microscope, it is recommended to
have a spare lamp and fuse (2 A, 250 V for 220 V supply / 4 A, 250 V for 110 V supply).
To perform any revision or maintenance work, contact your local distributor or the closest
ECLERIS office.
7.1 CLEANING
Before cleaning the Ecleris Microstar OM-100 Microscope, disconnect the power supply
cable form the electrical network.
7.1.1 CLEANING THE EXTERNAL SURFACES
Clean the external surface of the equipment using a piece of cotton or cloth moistened with mild
detergent or soap. Use only adequate products for the external cleaning of electrical equipment,
prepared in accordance with the manufacturer’s indications.
Perform the cleaning with special care, avoiding water or humidity access to the
equipment.
Do not use flammable products, especially alcohol when the light source is not cold. If flammable
products were used, do not turn the light source on until one (1) hour after the cleaning since an
explosive mixture may be produced.
Do not use detergents, solvents or any other abrasive agent.
Do not autoclave any part of the device.
It is recommended to clean the exterior surface of the device every 15 days.
7.1.2 CLEANING OF OBJECTIVE LENS AND EYEPIECES
Smoothly rub the lens surface using circular movements with a thin tissue paper moistened in
acetone.
