95
input value shall be 128-digit. It shall not be left in blank.
After completing all the setups please click save button, system goes back to the previous menu.
Figure 5-33
5.6.5.1 Network Setting
Network setting interface is shown as in Figure 5-34. Please draw a circle to enable
corresponding function and then double click current item to go to setup interface.
Figure 5-34
5.6.5.2 IP Filter
IP filter interface is shown as in Figure 5-35. You can add IP in the following list. The list supports
max 64 IP addresses. System supports valid address of IPv4 and IPv6.
Please note system
needs to check the validity of all IPv6 addresses.
After you enabled trusted sites function, only the IP listed below can access current NVR.
If you enable blocked sites function, the following listed IP addresses can not access current NVR.
z
Enable: Highlight the box here, you can check the trusted site function and blocked sites
function. You can not see these two modes if the Enable button is grey.
z
Type: You can select trusted site and blacklist from the dropdown list. You can view the IP
address on the following column.
