138
7
Web Operation
7.1
General Introduction
The device web provides channel monitor menu tree, search, alarm setup, system setup, PTZ
control and monitor window.
Important
The following operation is based on 16-channel series device. For the 32-channel series
product, there is 32-channel option.
7.1.1
Preparation
Before log in, please make sure:
z
Network connection is right
z
NVR and PC network setup is right. Please refer to network setup(main
z
menu->setting->network)
z
Use order ping ***.***.***.***(* NVR IP address) to check connection is OK or not. Usually the
return TTL value should be less than 255.
z
Open the IE and then input NVR IP address.
z
System can automatically download latest web control and the new version can overwrite the
previous one.
z
If you want to un-install the web control, please run
uninstall webrec2.0.bat
. Or you can go to
C:\Program Files\webrec to remove single folder. Please note, before you un-install, please
close all web pages, otherwise the un-installation might result in error.
z
Current series product supports various browsers such as Safari, firebox browser, Google
browser. Device only support 1-channel monitor on the Apple PC.
About PoE address setup, operation and allocation.
1) Insert PoE
After you insert PoE, device may try to set a corresponding IP address of the Switch network
adapter. First, system tries to set via arp ping. It then uses DHCP if it finds the DHCP is enabled.
After successfully set IP address, system may use Switch to send out broadcast, system thinks
the connection is OK when there is any response. Now system is trying to login the newly found
IPC. Now please check the interface, you can see the corresponding digital channel is active now.
You can see a small PoE icon at the top left corner. You can see the PoE channel, PoE port
information and etc from the connection list of the remote device interface (Chapter 5.6.11). For
the IP search list, you need to click the IP search to display or refresh.
2) Remove PoE
After you removed PoE, you can see the corresponding digital channel becomes idle (disable).
On the remote device interface, it is removed from the connected list. For the IP search list, you
need to click the IP search to refresh.
3) After you insert PoE, system follows the principles listed below to map channel.
a) If it is your first time to insert PoE, system can map it to the first idle channel. After
map, the channel can memorize the MAC address of the IPC. It is a
<Channel>---<IPC mac>
map. If current channel does not connect to other device,
system can memorize current MAC address, otherwise it can refresh to the newly
added device and memorize the
<PoE port>---<Channel>
.
