Guide Piece Replacement
1. Operate the cutter either forwards or backwards until the moving blade
disengages from the pinion gear and can be pulled free.
2. Remove the battery from the cutter.
3. Use a M2.5-sized Allen wrench to loosen and remove the screw which
secures the gear guide to the moving blade. Install the replacement guide
and tighten the screw. Repeat to replace the second gear guide.
4. Reinstall the battery pack. Feed the the moving blade into the gear
mechanism. Test the new blade movement. If necessary, repeat the
procedure from Step 1.
Battery Charging
1. After removing the battery from the power tool, insert it into the battery
charger. The red indicator will light up and indicate the battery is charging.
2. The green light comes on after approx. 30 mins when the battery is fully
charged.
3. Remove the battery from the charger and install into the handle of the power
tool sliding it into the base of the tool handle until it clicks into place. The
battery should be secured and unmoveable.
4. The charger will not operate effectively if overheated. Allow 10 minutes to
cool down between charges if charging consecutive batteries.
ATTENTION
DO NOT dispose of this battery in a fire or
otherwise abuse the battery.
DO NOT short circuit battery output terminals
DO NOT disassemble or modify the battery. This
may lead to short circuiting the battery cells
causing personal injury or damage to the
battery.
Keep your fingers away from edge of the moving
blade when feeding it into the gear mechanism.
The switch may have moved from the NEUTRAL
position.
6
