•
“CONTINUING IN x SECONDS”
(10) After approximately one minute, the GPS 400W will start Self Test. Several screens
of information will be displayed. When a flashing OK? is displayed, press ENT.
(11) The INSTRUMENT PANEL SELF-TEST screen is displayed, with a flashing OK?.
Press ENT.
(12) Rotate the GPS 400W power knob fully counter-clockwise, past the detent to the
OFF position. Wait for GPS 400W screen to go off.
B. Enter Configuration Mode.
(1) While pressing ENT, rotate the GPS 400W power knob clockwise past the detent to
the on position. Continue to hold ENT until the display comes on. Pressing and
holding ENT while powering on the GPS 400W places the unit in configuration mode.
(2) After powering on, the GPS 400W will start Self Test. Several screens of information
will be displayed. When a flashing OK? is displayed, press ENT.
(3) The INSTRUMENT PANEL SELF-TEST screen is displayed, with a flashing OK?.
Press ENT.
(4) MAIN ARINC 429 CONFIG screen should be displayed. If it is not, rotate the power
knob to the off position, wait for the unit to power off, and repeat section B.
C. Configure ARINC 429 Interfaces.
(1) ARINC 429 interface configuration is performed on the MAIN ARINC 429 CONFIG
page. Different configuration screens may be selected using the small right knob
while in configuration mode.
(2) While on the MAIN ARINC 429 CONFIG screen, press the small right knob to turn on
the cursor. The cursor may be moved to different fields by rotating the large right
knob.
(3) With the cursor at the IN 1 / SPEED field, rotate the small right knob to select Low.
Press ENT.
(4) With the cursor at the IN 1 / DATA field, rotate the small right knob to select EFIS /
Airdata Press ENT. For aircraft configured for (Standby Indication and Electrical
Provisions Package option), on the L GPS400W select Off. Press ENT.
•
For left GPS 400W on aircraft NOT configured for (Standby Indication and
Electrical Provisions Package option), rotate the small right knob to select EFIS /
Airdata. Press ENT. If the EFIS / Airdata selection is grayed out (not selectable),
select OFF and return to this field to select EFIS / Airdata after other fields on the
page have been configured
•
For the Right GPS 400W, regardless of configuration, rotate the small right knob
to select EFIS / Airdata. Press ENT. If the EFIS / Airdata selection is grayed out
EA500 Aircraft Maintenance Manual — 06-117751
Temporary Revision No. 34-21
EFFECTIVITY: 0001-0262, POST SB 500-99-005; AND
0266-0267; ALL POST MB 500-31-018
34-50-10
CONFIG A
Page 204
Sep 30/20
© 2020 Eclipse Aerospace, Inc.