5.
Transponder–2 Adjustment/Test (Standard System) with UC-584 Antenna Coupler
SUBTASK AMM-34-50-20-071-C-701-002-A
* * * 0001-0104, 0113-0115, 0120, 0123-0124 POST SB 500-99-002; 0105-0112, 0116-0119,
0121-0122, 0125-0265 POST SB 500-99-005; AND 0266-0267; ALL POST MB 500-31-016,
MB 500-31-018. and MB 500-34-030
A. Begin adjustment/test as follows:
(1) Perform Job Set-Up with UC-584 Antenna Coupler, refer to
(2) Use the small rotary knob on the left PFD to select XPDR page.
NOTE: The XPDR select page will time out and switch back to the COM page after
30 seconds. The operator will have to select XPDR page from time to time
during this test.
(3) Push ACTIVE soft key, upper right button, on the left PFD to select XPDR 2.
(4) Make sure that Transponder 2 (XPDR 2) is in STANDBY MODE.
B. Transponder-2 Setup
(1) Push CODE soft key on right PFD and enter the transponder code provided by the
control tower for this test. If no code was assigned, enter 1200.
C. Transponder-2 MODE A,C,S Test using Transponder Test Set, IFR6000
(1) Power up the Transponder Test Set (IFR 6000). After tester performs Self Test, push
SETUP button on the test set to bring up the SETUP-XPDR page. If necessary,
continue pressing SETUP button until tester cycles to SETUP-XPDR page.
(2) On the Transponder Test Set (IFR 6000) SETUP-XPDR page, use NEXT PARAM or
PREV PARAM soft keys to select each parameter, and the “arrow” DATA keys to set
the values listed below.
•
RF PORT: DIR W/COUPLER
•
CPL CABLE LOSS: Set to loss found on cable.
•
COUPLER LOSS: Set to loss found on coupler.
•
UUT ADDRESS: AUTO
•
MANUAL AA: Ignore
•
DIVERSITY TEST: OFF
•
CHECK CAP: YES
•
PWR LIM: FAR 43
•
RAD47: OFF.
(3) Push XPDR button to go to the XPDR-AUTO TEST page.
(4) Push CONFIG soft key to display the XPDR-CONFIG SCREEN page.
(5) On the XPDR-CONFIG SCREEN, scroll to GENERIC MODE S using the up/down
DATA keys.
EA500 Aircraft Maintenance Manual — 06-117751
Temporary Revision No. 34-21
EFFECTIVITY: NOTED
34-50-20
CONFIG C
Page 508
Sep 30/20
© 2020 Eclipse Aerospace, Inc.
