Eclipse SunRoof Plus, Installation Instructions Manual

Tools Needed for BOTH versions:  

 
4 & 6mm Allen wrenches 
13mm open end wrench 
Large level 
Tape measures 
Tools for mounting hardware – neither provided 

Flat Mount – Version B 

(mounts on top of an existing structure) 

Determine the mounting area for the unit.  The entire unit is fully supported by the 
four to six Flat Mount Brackets provided (if unit projection is 16-6 or greater, six 
brackets are provided).  
 
The bracket placement – left to right.  This should be the Total Unit Width 

MINUS

 a 

minimum of 4” to a Maximum of 36”

 IN

 on each side.  

 
Bracket placement front to back: CANNOT exceed the lengths of the Guide Rails. 
Back/Top Bracket mounting locations should be as far back as possible to properly 
support the Cassette Box. 
The Front Bracket location must be within 36” from the end of the Guide Rail. If the 
Guide Rails are not cantilevered, we suggest placement of about 6” from the end.  If 
the unit ships with 6 total brackets, place a Bracket near the middle length of each 
Guide Rail for mid way support.  
 
The proper pitch to allow the unit to shed water is 1

4

 degrees or a

 3 on 12

 pitch (1’ 

drop from every 

4'

 of projection). If this pitch cannot be achieved, please inform the 

customer that the product is for sun protection only.  Even with proper pitch, the cover 
may hold water; therefore the unit should not be left out unattended.