Once all Brackets are properly aligned, DO NOT fully tightened them down yet. Place
each Guide Rail into the Brackets and THEN tighten the 4mm Allen Set Screws on
both sides of the Brackets to secure the Guide Rail and then tighten the Brackets to
your structure.
Adjust the Guide Rails so they are parallel by taking several measurements as shown
below. Take your time with this step which will save you hours of adjustment later.
Adjustments can be made on the
Flat Mount Bracket
(6mm hex)
If the Guide Rails
are not the same, measure a perpendicular position between the
Cassette Box and the Guide Rails to be certain the system is square.
When adjustments have been completed, tighten the locking screw thoroughly with a
6mm Allen wrench.
Proceed to general instructions
Summary of Contents for SunRoof Plus
Page 17: ......
