V&T Technologies Co., Ltd.
http://www.ecodrivecn.com
Chapter 4 Using Instructions of Operation Panel
31
4.3 Description of Keys on Operation Panel
Note:
The ENTER key of shuttle type operation panel is equivalent to PRG Key.
Using PRG key continuously can realize fast browse of all function codes.
Symbol
Name
Function
Key-type
Shuttle-type
Programming key
PRG
1
、
Enter each level of menu
2
、
Confirm data storage
3
、
Check function code in sequence
4
、
Confirm the running command reference mode with M key
Escape Key
ESC
1
、
Back to first level menu from second level menu; Back from first
level menu to standby status, running status, and fault status
2
、
Give up data storage after modifying data.
3
、
Back to basic menu mode after pressing this key for more than 5s.
Refer to 4.4.3. When LCD cannot display all the function codes,
use this method to re-display all the function codes.
4
、
After using >> key to switch from fault display to Stop / Run
parameter display, press ESC to back to fault display status.
Knob+
Knob-
Increase Key
∧
1
、
In first level menu, increase function code according to edit bit.
2
、
In second level menu, increase the function code data.
3
、
In stop/run status, increase the input frequency or close loop input.
Decrease Key
∨
1
、
In first level menu, decrease function code according to edit bit.
2
、
In second level menu, decrease the function code data.
3
、
In stop/run status, decrease the input frequency or close loop input.
Shift Key
>>
1
、
In first level menu, use >> key to move edit bit of PX.YZ menu
2
、
In second level menu, use >> key to move the edit bit of data
3
、
In stop/run status, switch the panel display parameters such as
frequency, current and voltage.
4
、
In fault status, change from fault display to stop/run display.
Run Key
RUN
1
、
When running command is given via operation panel, the key is
used to control the start of inverter.
2
、
After setting the parameter auto tuning,start parameter auto tuning
for inverter startup
Stop/Reset Key
STOP/RST
1
、
When running command is given via operation panel, the key is
used to control the stop of inverter.
2
、
This key is used as a stop key when inverter only has fault alarm
but does not stop.
3
、
When the inverter has fault and has stopped, this key is used as
RESET key to clear the fault alarm.
Multi-function Key
M
See table 4-1 for the using method of multi-function key and the
meanings of MULTI indicator.
Forward/reverse
Key
FWD/REV
When running command is given via operation panel, this key is used to
confirm the output direction of inverter
