42
d) Working with macros
Any number of scenarios can be set up using the 4 freely programmable macros (a ‘macro’ is a sequence of several
functions/commands). A specific state or operating mode can be programmed for each room controller and each remote
switch, which is then selected by using its corresponding macro.
You can, for instance, set your living room to the lowering temperature, roll out the awning in your winter garden and switch
on the ventilation all with the press of one button.
You can assign a plaintext name (10 characters) to each macro, such as ‘coming’, ‘going’, etc.
With the help of the FS20TS telephone remote control or the HMS/FHZ radio telephone dialler (neither are included in the
delivery, but are available separately!), you can also activate these macros while you are on the move from your mobile
phone or from your office.
So, for instance, you can heat up your bath and switch on your outside lights while still driving home in your car.
X
X
X
X
X
1. Activating a macro
A macro can be activated in 3 different ways:
• Directly on the device using the ‘MAKRO’ button
• Using the FS20TS telephone remote control
• Using the HMS/FHZ radio telephone dialler (alarm dialler)
To activate a macro directly on the device, proceed as follows:
• Briefly press the ‘MAKRO’ button once.
• Select the desired macro using the scroller.
• Confirm the macro by pressing the ‘MAKRO’ button once.
• The display briefly shows ‘aktiviert.’ (activated).
The FHZ1000 then returns to the normal operating mode.
Activation using the FS20TS telephone remote control is described in section 8. Activation using the HMS/FHZ radio
telephone dialler is described in section 9.
X
X
X
X
X
2. Entering the name of the macro
At the factory the 4 macros are named ‘Makro 1’ to ‘Makro 4’.
You can change these names as follows:
• Briefly press the ‘
x
’ button once.
• Select ‘Sonderfkt.’ (special function) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Makros’ (macros) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Namen änd.’ (change name) using the scroller.
• Briefly press the ‘
x
’ button once.
• Use the scroller to select the macro whose name you wish to change.
• Briefly press the ‘MAKRO’ button once.
• A cursor blinks on the display.
• Move the cursor using the ‘
w
’or ‘
x
’ button to the letter that you wish to change.
FHT 8W Heat Demand Relay
Installation and User Guide
Product Code EHC-FH06
1
