ETS 73
0548-990-51---60g_2019.10.indd
B
A
C
D
400
620
1,5
1,5
27
52,5 / 76,5
65,5 / 89,5
E F
C
G
D F
E
G
F
D
1,5 Nm
B
!
0548-990/52g
Page 41 of 98
Mounting and operating instructions
Attention:
Check the motional sequence of the door leaf:
The rods must not touch. If the glider (C) makes screeching noises, it needs to be lubri
-
cated with a little WD40.
Drive mechanism standard
2. Mount the drive mechanism.
3. Close the door leaf.
4. Install the mounting profile (E) on the door leaf.
5. Screw down the rotating arm (B) parallel to the drive
mechanism.
6. Push the guide profile (G) over the glider (C) and hook
it into the mounting profile (E).
7. On both sides insert and screw down (with 1,5 Nm)
the expansion element (F).
8. Snap in the covering caps (D) on both sides.
forward to chapter 4.6
Inverse application
2. If existing:
Sub-assemble the drive-internal open position stop
piece, integrated in the drive mechanism (see Option
instructions 0548-992/02).
3. Mount the drive mechanism.
4. Install the mounting profile (E) on the door leaf.
5. Hook the guide profile (G) into the mounting profile
(E), on both sides insert and screw down (with
1,5 Nm) the expansion element (F).
6. Completely open the door leaf (max. 115°).
7. Insert glider (C) into guide profile (G) and screw down
the rotating arm (B) on the drive mechanism.
8. Snap in the covering caps (D) on both sides.
back to page 25
