ETS 73
0548-990-51---60g_2019.10.indd
Display
Joystick
dAxis
–
+
dAxis
–
+
Default
6
4
3 s
5 s
0,2 s
OFF
0,5 s
2,0 A
OFF
OFF
4
4
0
0
95°
*
STD-PH
*
OFF
*
0/+8 cm
Rod dep.
*
5 A
Vo
Vc
TOEx
TKey
TDelay
FDelay
TLock
FLock
FSlam
FWind
Fo
Fc
Foh
Fch
Ao
Rod
Invers
dAxis
FTic
0..14 (5…50°/s)
0..14 (5…50°/s)
0...60 s
0...180 s
0,0...4,0 s
0,0...7,0 A
0,0...4,0 s
0,0...7,0 A
0...10
OFF
OPEN
CLOSE
BOTH
0...9
0...9
0...9
0,0...3,5 A
20...(190°) Rod dep.
STD-PH
SLI-PL
SLI-PH
WIN-PH
DIR-PH
DIR-PL
OFF
ON
-8...+25 cm
Rod depending
5...14 A
0548-990/52g
Page 67 of 98
Mounting and operating instructions
scroll
change
7.4.1
Motional parameters (PARAMETER)
7.4
Adjustings
The parameters can be changed on the
control unit by means of the display and the
joystick.
The movements of the joystick have the
following effects:
• Vertical joystick movement (upward/downward)
Scroll through the displayed information.
• Horizontal joystick movement (to the left/to the right)
Change the settings.
• Shortly press in the joystick in the rest position
Validation OK.
Mounting plate (option)
Parameter Description
Opening speed (velocity open)
Closing speed (velocity close)
Hold-open time opening element inside/outside (time hold opening element inside/outside)
Hold-open time Key (time hold opening element Key)
Starting delay (time delay lock)
Relieving force during unlocking (force delay), only effective if TDelay is > 0
Door rectification time (time press close)
Pressing force during locking (force lock), only effective if TLock is > 0
Accelerating function (force slam)
Obstacle detection optimized for exterior doors (force wind)
Opening force (force open)
Closing force (force close)
Hold-open force (force open hold)
Interlocking force (force close hold)
automatically programs FLock and FDelay if these are 0
Opening angle of the door (angle open)
If the opening angle is changed during the operating mode OPEN, the operating mode MANUAL needs to be
selected for closing the door.
Type of rod assembly (Rod)
Normal rods
pushing fonction
Sliding rods
pulling fonction
Sliding rods
pushing fonction
Wing mounting
pushing fonction
without rods
pushing fonction
without rods
pulling fonction
Inverse application
In the event of a power failure/error, the door leaf is opened by spring power from any position (unless it has
not been locked). The position of the motor connector is reversed with regard to the standard drive mecha
-
nism. The electric lock/holding magnet must be connected in reverse order in comparison to the standard
drive mechanism (see wiring diagram E4-0141-713_ECO).
Distance between rotation axis of the door hinges and the mounting level of the drive mechanism
(distance Axis). dAxis is an approximate value. Depending on the installation situation, dAxis may have to be
adapted.
Closing force in closed position before Teach (only visible if Inverse is ON).
Setting range
* Note:
A renewed setting-up procedure
(Teach) is required.
