ETS 73
0548-990-51---60g_2019.10.indd
A
B
0548-216
0548-990/52g
Page 96 of 98
Mounting and operating instructions
13.8.2
Radio PCB
A radio control PCB can be plugged into the control of the drive mechanism. Using a hand-held
radio transmitter/radio transmitter/radio code lock, this PCB can be programmed with a code,
upon which the drive mechanism can be controlled via this element.
In cases where several elements shall be used for controlling the same drive mechanism, all the
transmitters need to be programmed with the same code (which is transmitted from the standard
transmitter to all the additional transmitters).
On the other hand, several drive mechanisms can be simultaneously controlled by one single
button.
Teaching the element
1. Keep the button (A) on the radio control
PCB depressed (at least during 3 seconds)
until the red LED (B) flashes at regular inter
-
vals.
2. Maintain the desired button of the ele
-
ment depressed until the red LED (B) on
the radio-control PCB lights up for about 2
seconds.
3. As soon as the red LED (B) is extinguished,
this means that the code has been memo
-
rized in the radio control PCB.
