@2021 EcoAir
-
C480 V1
Page 6
All rights reserved
SETUP CONTINUOUS DRAINAGE
Use a hose with an inner diameter of 11.5mm for continuous drainage:
1.
Remove the Water Tank (A7)
2.
Remove the Tank Plug (A9) from the Continuous Drainage Outlet (A8) at the bottom of the
water tank (store safely as you will need to plug it when not using the continuous drainage).
3.
Insert the Continuous Drainage Hose (B1) into the Continuous Drainage Outlet (A8).
4.
Reinsert the water tank to the correct position.
5.
The Continuous Drainage Hose (B1) must lead to an appropriate drain at a downward slope with
no sharp bends.
NOTE:
•
Ensure the tank and the hose are securely fitted in position before turning the
dehumidifier on.
•
Never leave the end of continuous drainage hose outside when the temperature is
below 1°C to avoid leakage. (When the outdoor temperature is at freezing point the
water will not flow freely and this will cause a blockage consequently pushing the any
condensation back to the dehumidifier and leakage will occur).
Slide water the tank out
(A7)
Remove the plug (A9)
Push the Continuous
Drainage Hose (B1) into
the Continuous Drainage
STEP 1
STEP 2
STEP 3
A8
A9
A8
B1