@2022 EcoAir
-
V1.4
Page 8
All rights reserved (E&OE)
OPERATION
ON/OFF
TO
OPERATE
UNIT
•
Place the unit in an upright position on an
even level surface.
•
Plug the unit into the mains socket.
•
Turn the Humidistat Dial clockwise to
select desired mode. (Power ON
indicator will light up)
•
Turn anti
-
clockwise to reduce the power.
•
To switch the unit OFF, turn anti
-
clockwise all the way.
LOW/MEDIUM/HIGH/LAUNDRY
(USING THE HUMIDISTAT DIAL)
Low
•
Select to keep the room at a comfortable
level
•
Dries the air to approximately 70% RH and
stops dehumidifying.
Medium
•
Select to run in Medium mode
•
Dries the air to approximately 50% RH and
stops dehumidifying.
High
•
Select High mode to quickly control high
levels of humidity
•
Dries the air to approximately 40% RH and
stops dehumidifying.
Laundry
•
Use for drying clothes. The dehumidifier
will continuously dry the air until the
settings are changed manually.
•
Place the laundry on a drying rack with a
minimum distance of 40cm away from the
dehumidifier. Once laundry is dry, revert
back to Low or Medium Economy modes.
•
Only use the Laundry Mode function over a
short period of time. Avoid using the
laundry mode unattended.
ECONOMY/TURBO MODES
(USING THE ECONOMY TURBO SWITCH)
Economy
Select Economy mode for maximum
energy saving and quiet operation.
•
Use this mode for normal daily use.
•
Highly recommended for night use.
Turbo
Select Turbo mode for rapid dehumidifica-
tion.
•
For quick drying, turn humidistat clock-
wise to the end and slide switch to
TURBO.
Tip: Once you reach desired RH, switch from
TURBO
to
ECONOMY
for energy savings. Use
a hygrometer to measure the ambient
humidity.
IMOPORTANT:
Avoid using the Turbo mode for normal daily
use. You may use to dry very damp rooms over 2 –
3
days
and for Laundry. For daily use, select Economy mode.
CHECK LIGHT
•
Lights up when water tank is full or not
properly inserted.
Water Full/
Check
Indicator
•
Check and clean the filter. Ensure filter is
cleaned every 2 weeks.
•
Allow the dehumidifier to cool down.
Switch OFF and leave for 30 minutes and
turn on again.
•
Check that the tank is inserted correctly
and securely.
•
Check Troubleshooting.
TIP:
When the check light comes on, move it to another
room where the temperature is warm such your living room
to test.
3D LOUVRE
Wide
Airflow
•
Rotate to the WIDE position
Spot Air-
flow
•
Rotate to the SPOT position
Note:
To avoid damage, do not touch the
louvre whilst in operation.
