@2022 EcoAir
-
V1.5
Page 6
All rights reserved (E&OE)
SETUP CONTINUOUS DRAINAGE
STEP 1
Knockout
STEP 2
Hose
STEP 3
Hose
Use a hose with an inner diameter of 12mm for continuous drainage:
1.
Use a screwdriver to remove the knockout at the back.
2.
Ensure the water tank is well fitted in position. Then, push the hose
(B1)
through the knockout
and make sure it attaches firmly to the open tap securely.
3.
Once the hose is securely attached to the open tap, lead the other end of the hose to an
appropriate drain at a downward slope with no sharp bends.
NOTE:
•
When using the dehumidifier with a continuous hose attached, never pull out the
tank. This may cause water leakage or damage to the open tap. If you need to re-
move the water tank, ensure that the hose is disconnected first.
•
Never leave the end of continuous drainage hose outside when the temperature is
below 1°C to avoid leakage. (When the outdoor temperature is at freezing point the
water will not flow freely and this will cause a blockage consequently pushing the any
condensation back to the dehumidifier and leakage will occur).
