FITTING & LIGHTING THE ECOBURNER:
The EcoServe GN may be powered by one or two EcoBurners. Powering with one EcoBurner
is suitable for most indoor uses. Powering with two is best suited to outdoor use.
1. For even heat distribution when powering
with just one EcoBurner, the EcoBurner
should be fitted in the Central Spring Clip
position
(4)
as shown in the diagram above.
1. The legs should be in the unfolded position before
beginning.
2. Lay the EcoServe GN upside down on a soft surface to
prevent scratching.
3. Unscrew both Knurled Nuts
(5)
and lift the cover away
from the Locking Screws
(6)
. When refitting, be careful to
align the cover holes with the Locking Screws
(6)
.
4. All parts of the EcoServe GN should be wiped clean with
a damp cloth to retain the best quality finish. Do not use
abrasive cleaners as these will damage the product.
2. When powering with two EcoBurners, it is
only possible to fit them in the Outer Spring
Clip positions
(3)
as shown in the diagram
above.
3. To fit the EcoBurner, first light the EcoBurner
as normal. The burner head should be glowing
orange before the EcoBurner is positioned.
Align the EcoBurner with the Spring Clip cradle
and push firmly into place.
4. The EcoBurner Reflector Plate should be
gripped by the spring clip as shown above.
MAINTENANCE & CLEANING
The Hot Air Cover
(7)
may be removed for cleaning.
(5)
(5)
Please retain this leaflet for future reference.
EcoBurner Ltd., Unit 5, Gulfstream Ave., Airside Business Park, Waterford X91RF20 Ireland
+353 51353806 www.ecoburner.com info@ecoburner.com
