EN
6
4. Connect AC wires from the left side and DC wires from the right side. It is recommended
to route wires through corresponding inlets and outlets (e.g. AC input wires shall always
go through the AC Input Inlet while AC output wires shall go through the AC Output
Outlet). This will prevent potential wiring and electrical safety issues.
2. Remove the surface cover and the wiring cover plate to expose the inner panel.
3. Remove the retainers near the input inlets and the load outlets.
All wires must go through the inner panel for safe and protected connection
to the Smart Distribution Panel.
1.
AC Output Outlet
2.
AC Input Inlet
3.
DC Output Outlet
4.
DC Input Inlet
2
2
1
比例
1.000
比例
1.000
2
3
4
2
1
Summary of Contents for EFM100-LD-HV
Page 1: ...AC DC SMART DISTRIBUTION PANEL User Manual V1 0 EFM100 LD HV...
Page 2: ......
Page 19: ...Ecoflow App...
