Ecolab GEOCENTER, Installation And Operation Manual

iv

7.0  SYSTEM OpERaTING fEaTURES ............................................................... 11

7.1  Power Lights ............................................................................................11

7.2  Feed Light ...............................................................................................11

7.3  100% Light ..............................................................................................11

7.4  Temperature Compensation ....................................................................11

7.5  Optional Jumper Settings ........................................................................11

8.0  SERVICE ........................................................................................................ 12

8.1  Regular Inspection ................................................................................. 12

8.2  Squeeze Tube Replacement Instructions ............................................... 12

9.0  TROUBLESHOOTING .................................................................................... 13

9.1  Unit does not operate - No Power Light. ................................................ 13

9.2  Unit does not feed - Power Light and Feed Light on. ............................. 13

9.3  Unit does not feed - Power Light on, Feed Light not on. ........................ 14

9.4  Feeds continuously - Feed Light not on. ................................................ 14

9.5  Feeds continuously - Feed Light on. ...................................................... 14

9.6  Fluctuating titration. ................................................................................ 15

9.7  Excessive detergent consumption. ......................................................... 15

9.8  Rinse Injector does not activate. ............................................................ 15

9.9  Rinse Injector runs, no rinse additive being injected. ............................. 16

9.10  Rinse Injector runs continuously ............................................................ 16

9.11  Rinse Injector will not prime. .................................................................. 16

9.12  Excessive squeeze tube wear. ............................................................... 16

9.13  Fuse on Speed Rinse P.C. board is blowing repeatedly. ........................ 16

10.0  REpLaCEMENT paRTS ................................................................................ 17
11.0  OpTIONaL pRESSURE SWITCH INSTaLLaTION ....................................... 18