!
Do not displace the pump by lifting it with the help of the flex. Fix an additional
wire to the pump housing to lift the pump out of the water.
!
VT Econo Pond Pumps are exclusively made to displace water. This means that
transport of any different liquids explicitly excluded.
!
The use of these pumps in swimming pools is not allowed.
!
The pump housing should be installed at least 10 cm and at most 2 m below
water level.
!
The pump should always be placed as level as possible and not in the bottom
sludge. If necessary, you should use an elevation, made from a number of stones.
!
The pump should be used exclusively in the water (wet installation).
!
The temperature of the water to be displaced may be maximum 35 °C.
!
When the pump is completely installed, it can be connected to the power supply.
DESIGNS
VT Econo Pond Pumps are available in 4 designs, namely:
l
VT Econo pond pump 2000
capacity on water level 1950 l/h and delivery head 1,95 m for up to 5000 litres water
l
VT Econo pond pump 4000
capacity on water level 4000 l/h and delivery head 3,0 m for up to 10.000 litres water
l
VT Econo pond pump 5000
capacity on water level 4900 l/h and delivery head 3,3 m for up to 12.500 litres water
l
VT Econo pond pump 6000
capacity on water level 5800 l/h and delivery head 4,1 m for up to 15.000 litres water
Parts
1. Preliminary filter scale (stops coarse dirt particles)
with internal elevation for the pump motor
2. Hose Socket with quick release coupling for connecting the return hose
3. Electrical safety cable 10 metres
INSTRUCTIONS FOR USE
VT Econo Pumps are supplied completely in a box. They are ready for use in a pond.
If necessary, use an elevation of stones or a stand. When the pump has been installed
in the pond, you can put in the plug.
Attention
Inspect the flex and the electric connections prior to use for any damage. Take care
that the plug and the receptacle are dry. For safety reasons any repairs to the flex and
the pump motor may only be carried out by VT (see guarantee).
MAINTENANCE
The VT Econo Pond Pumps are equipped with motors which have a long life-time
and low energy use. The motors are entirely closed watertight and in principle they
are maintenance free. The built-in security device will switch the motor off in case
of overheating. Having cooled down for some time, the motor will start again.
