16
Step 9. – Connect Bypass Assembly to ecoPLUS™ Valve Head
Connect the other bypass assembly to the ecoPLUS™ valve head in the same manner as
noted in Step 7.
Step 10. – Connect the ecoPLUS™ Tank to the Inlet Assembly
Position the ecoPLUS™ media tank to align the bypass assembly with the inlet assembly
attached to the cartridge filter housing cap.
Note that the black base of the media tank is not permanently attached to the rest of the
tank. If your tank appears to be crooked, the base has likely been knocked out of alignment
during shipping. This can be correct by picking the tank up and tapping it on a hard surface
while holding it perpendicular to the floor. A few light taps will generally straighten it out.
Thread the inlet assembly on to the bypass assembly as shown in the same manner as
previous steps. There is a small amount of “play” in the bypass assembly to help address
minor misalignments. This is normal and will prevent undue stress on the components.
Make sure that the tank sits perpendicular to the floor.
Summary of Contents for EP-600-ULT
Page 8: ...8 Step 1 Pre Installation Inspection...
Page 17: ...17 go to next page...
