4
Safety Guides
=
The water treatment system requires a minimum water flow of 3 gallons (11.4 L) per minute at the inlet.
Maximum allowable inlet water pressure is 100 psi (7.0 kg/cm
2
). If your house water pressure is over the maxi-
mum, install a pressure reducing valve in the water supply pipe to the system (Adding a pressure reducing valve
may reduce the flow). If your home is equipped with a back flow preventer, an expansion tank must be installed in
accordance with local codes and laws.
=
Temperature of the water supply to the softener must be 40-100°F (5-38°C). Do not install on hot water.
=
The water treatment system works on 24V DC electrical power, supplied by a direct plug-in power supply (includ-
ed). Be sure to use the included power supply and plug it into a nominal 120V, 60 Hz household outlet that is in
a dry location only, grounded and properly protected by an overcurrent device such as a circuit breaker or fuse.
=
Do not use this system to treat water that is microbiologically unsafe or of unknown quality without adequate dis-
infection upstream or downstream of the system.
European Directive 2002/96/EC requires all electrical and electronic equipment to be disposed of accord-
ing to Waste Electrical and Electronic Equipment (WEEE) requirements. This directive or similar laws are
in place nationally and can vary from region to region. Please refer to your state and local laws for prop-
er disposal of this equipment.
Do not return the water treatment system to store.
If you have any questions, or there are missing parts or damage, please call
Toll Free 1-800-693-1138
or visit
www.ecopure.com
When you call, please be prepared to provide the model and serial number, found on the rating decal,
located on the rim below the salt lid hinges.
Dimensions
52.4 cm
8.6 cm
OUT
IN
43.8 cm
TOP VIEW
SIDE VIEW
FRONT VIEW
108.6 cm
94.0 cm
IN - OUT
FIG. 1
