8
eCopy ScanStand Assembly Instructions
Fastener Kit #3: P/N 16-5001-C
Components shown full size to help identification
3.1
Insert bolts through strut from back of frame.
3.2
Place washer and nut on each bolt. Turn only 2-
3 times leaving bolt heads extended at least 16
mm (5/8 inch) from rear of frame.
Note bolt head alignment and required gap
3.3
Slide arm support post over bolt heads, flat side
against rear frame, fitting the two bolt heads
into the T-slot on the post.
Tip
: While holding post with one hand, rotate bolt
heads to align edges parallel to T-slot.
3.4
Position post at desired height. Typically, the
bottom of the post is aligned with the top edge
of the rear frame's lower cross-member.
3.5
Tighten nuts securely using 13 mm wrench.
Frame
Bottom of arm
support post
Step 3: Arm support post attachment
You can mount the arm support post on any one of the available vertical struts on the rear frame (see
