eCopy ScanStand Assembly Instructions
1
Planning the installation
You can assemble the eCopy ScanStand in several configurations. Determine the best configuration so the arm,
touch screen, and keyboard do not interfere with copier access. In most situations:
> If the finisher is on the left of the copier, configure the PC and arm at the right of the assembly.
> If the finisher is on the right of the copier, configure the PC and arm at the left of the assembly.
> Leave 6-9 inches (15-23 cm) of clearance between the ScanStation and the copier access door.
Variations to these standard configurations are possible to accommodate paper reservoirs or other accessories
(see next page).
You can also place the PC behind the copier, as shown below.
Typical configuration for finisher on left
Typical configuration for finisher on right
Configuration if PC is placed behind and left of copier
Configuration if PC is placed behind and right of copier
