8
Then take front gill away in parallel. Reinstall After clean, first step put top latch
of front grill in front panel slot then turn over down and push bottom latch of
front grill in front parallel slot.
Wipe off fan blade and front grill (if dirty) with damp washcloth. The fan
requires no maintenance (with the exception of the first time it is used, when it
may be necessary to give it a gentle push to get it started). If the fan squeaks,
a drop of lightweight oil may be needed on the fan shaft.
11.
REPLACING THE FUSE
A fuse holder is located on the back of the unit next to the power cord.
To replace or check the fuse:
Remove the fuse holder by pressing on the clip and pulling straight out.
If the fuse is blown:
replace with the backup fuse. Insert the new fuse into the fuse
holder. Press the assembly straight in until it latches.
If the fuse holder cap is not installed correctly, the unit will not operate.
110 volt models: fusing current no more than1.0 Amp.
12.
TROUBLE SHOOTING GUIDE
Indicators of Operation
(Operation of the ozone and power indicator lamp).
Ozone switch is suggested to be operated when room
is unoccupied.
Open the door and window when you back to the room
if Ozone operated for several hours.
Turn the unit on and check that the small red/orange
lamp is illuminated.
The lamp is located on front panel; one is silkscreen
‘
power
’ anther is silkscreen ‘
ozone
’.
