7
SETTING AND ADJUSTING CONTROLS
1. FAN CONTROL
The disbursement of cleansing properties is best accomplished with good air
circulation. The FAN control should be set as high as reasonably possible without
creating an undesirable noise level. This will be determined by personal preference
and the distance you wish the cleansing properties to be dispersed.
Note: A ceiling fan can also aid in distribution of cleansing properties.
2. PURIFIER CONTROL
PURIFIER control: Set the control at the nine o'clock position for one hour.
Adjust the PURIFIER control up or down after one hour based on the
following criteria:
1. In normal conditions it is not necessary to turn the PURIFIER control indicator
above the square-footage of the environment.
2. Keeping in mind the previous statement (#1), adjust the purifier so that the odor
of ozone fades into the background 15-30 seconds after entering the environment.
3. NORMAL / LOW SWITCH (100 & 110 volt models only)
For better purifier control in small areas (under 300 square feet), set the NORMAL /
LOW switch to LOW. The purifier output will be effective for 1/10th of the area
indicated by the current purifier control setting (for example: 3000 sq. ft setting = 300
sq. ft. coverage). For all other applications, set the switch to NORMAL.
4. SANITIZING AN AREA
To sanitize an approximately 12x12
area for mold, mildew, or bacteria,
turn the unit on high for 3-4 hours.
Caution: Always be sure a room or
area is UNOCCUPIED before
performing the above described
sanitizing procedure.
Air out room by opening door
and/or window.
Living Air Classic
Electronic Air Pu
rification System
Purifier
Control
Fan
Control
Normal / Low Switch
(100 & 110 volt models only)
