engLisH
Burner Assembly - Natural Gas
NATURAL GAS
Note: Connection of this product to Natural Gas must be
completed by a licensed gas plumber / installer only. Do not
attempt to install this product with Natural Gas without a licensed
installer present.
1. unpack burner box. remove all items and check against the items
listed on page 9 of the manual to ensure all parts needed are ready.
2. Ensure you have assembled the control panel, as outlined on page 10.
For the Round Burner go to step 4.
3. Linear burners only: (this step is not required for round burners).
attach the burner to the adapter plate (found inside the surround unit)
using the four bolts and nuts provided. ensure burner is attached to
the flat side of the adapter plate marked “For Gas Burner Only”. If
experiencing issues lining up the holes of the burner and the adapter
plate, please rotate the burner 180 degrees and try again.
4. Using two adjustable wrenches, remove the flex line from the burner orifice.
5. Using two adjustable wrenches, remove the #43 orifice from the gas
inlet of the burner.
6. Insert orifice #31 in the gas inlet of the burner and tighten using two
adjustable wrenches. Do not over tighten.
7. Re-attach the flexible gas flex line to the orifice. Do not over tighten.
8. Adjust air shutter to between
1
/
16
in (1.6mm) open to completely
closed, on each side of air shutter.
9. Ensure ignitor wire is secured to bottom of Ignitor.
10. Ensure grounding wire is secured to bottom of burner.
11. Place a protective towel over the Surround Unit. Carefully place
the burner on surround unit near opening without inserting burner
into the final location. Feed the flexible gas line, grounding wire and
the ignitor wire through the burner location and out the control panel
opening located on the side of the surround unit.
12. Using two adjustable wrenches, attach the flexible gas line to the
top valve fitting (outlet). Do not overtighten.
1/16”
(1.5)
